smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.2.2-xxxx-std-ipv6-64] (local build) Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net === START OF INFORMATION SECTION === Device Model: ST2000DM001-9YN164 Serial Number: W1E0DKYZ LU WWN Device Id: 5 000c50 04b3ca7bf Firmware Version: CC4H User Capacity: 2,000,398,934,016 bytes [2.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: 8 ATA Standard is: ATA-8-ACS revision 4 Local Time is: Mon May 13 11:54:21 2013 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 584) seconds. Offline data collection capabilities: (0x73) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 223) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x3085) SCT Status supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 087 080 006 Pre-fail Always - 204605100 3 Spin_Up_Time 0x0003 094 094 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 12 5 Reallocated_Sector_Ct 0x0033 099 099 036 Pre-fail Always - 2096 7 Seek_Error_Rate 0x000f 084 060 030 Pre-fail Always - 280967049 9 Power_On_Hours 0x0032 092 092 000 Old_age Always - 7058 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 11 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 5069 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 070 059 045 Old_age Always - 30 (Min/Max 29/32) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 9 193 Load_Cycle_Count 0x0032 095 095 000 Old_age Always - 10566 194 Temperature_Celsius 0x0022 030 041 000 Old_age Always - 30 (0 18 0 0) 197 Current_Pending_Sector 0x0012 085 084 000 Old_age Always - 2488 198 Offline_Uncorrectable 0x0010 085 084 000 Old_age Offline - 2488 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 236498079193105 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 58649384517519 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 77107625589710 SMART Error Log Version: 1 ATA Error Count: 5069 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 5069 occurred at disk power-on lifetime: 7016 hours (292 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 08 ff ff ff 4f 00 16:08:27.581 READ FPDMA QUEUED ef 10 02 00 00 00 a0 00 16:08:27.581 SET FEATURES [Reserved for Serial ATA] 27 00 00 00 00 00 e0 00 16:08:27.581 READ NATIVE MAX ADDRESS EXT ec 00 00 00 00 00 a0 00 16:08:27.581 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 16:08:27.580 SET FEATURES [Set transfer mode] Error 5068 occurred at disk power-on lifetime: 7016 hours (292 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 08 ff ff ff 4f 00 16:08:24.722 READ FPDMA QUEUED ef 10 02 00 00 00 a0 00 16:08:24.722 SET FEATURES [Reserved for Serial ATA] 27 00 00 00 00 00 e0 00 16:08:24.722 READ NATIVE MAX ADDRESS EXT ec 00 00 00 00 00 a0 00 16:08:24.722 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 16:08:24.722 SET FEATURES [Set transfer mode] Error 5067 occurred at disk power-on lifetime: 7016 hours (292 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 08 ff ff ff 4f 00 16:08:21.863 READ FPDMA QUEUED ef 10 02 00 00 00 a0 00 16:08:21.863 SET FEATURES [Reserved for Serial ATA] 27 00 00 00 00 00 e0 00 16:08:21.863 READ NATIVE MAX ADDRESS EXT ec 00 00 00 00 00 a0 00 16:08:21.863 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 16:08:21.863 SET FEATURES [Set transfer mode] Error 5066 occurred at disk power-on lifetime: 7016 hours (292 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 08 ff ff ff 4f 00 16:08:19.005 READ FPDMA QUEUED ef 10 02 00 00 00 a0 00 16:08:19.004 SET FEATURES [Reserved for Serial ATA] 27 00 00 00 00 00 e0 00 16:08:19.004 READ NATIVE MAX ADDRESS EXT ec 00 00 00 00 00 a0 00 16:08:19.004 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 16:08:19.004 SET FEATURES [Set transfer mode] Error 5065 occurred at disk power-on lifetime: 7016 hours (292 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 08 ff ff ff 4f 00 16:08:16.129 READ FPDMA QUEUED ef 10 02 00 00 00 a0 00 16:08:16.129 SET FEATURES [Reserved for Serial ATA] 27 00 00 00 00 00 e0 00 16:08:16.129 READ NATIVE MAX ADDRESS EXT ec 00 00 00 00 00 a0 00 16:08:16.128 IDENTIFY DEVICE ef 03 46 00 00 00 a0 00 16:08:16.128 SET FEATURES [Set transfer mode] SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 30 - # 2 Short offline Completed without error 00% 19 - # 3 Short offline Completed without error 00% 19 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.